SERE-LAB
Home › Training Guides › Hoist & Rescue
Hoist & Rescue

Hoist Emergency Response Training (HERT): Protocols & Safety

Operational principles of Helicopter Hoist Emergency Response Training (HERT), static grounding, deck communication, and emergency cable procedures.

Operational Scope of Helicopter Hoist Rescue

When landing a helicopter is impossible—on pitching fishing trawlers, wind turbines, narrow cliffs, or cramped offshore decks—rescue teams deploy hydraulic or electric hoist winches to lower rescue specialists, stretchers, and recovery strops directly onto the target zone.

Hoist Emergency Response Training (HERT) prepares both airborne hoist operators/rescue specialists and deck reception crews to manage high-consequence hazards: violent rotor downwash, swinging pendulums, high-voltage static electricity, and fouled hoist cables.

  • Static electricity grounding using weighted conductive discharge lines
  • Dynamic load swing damping and tag-line (hi-line) vessel deck control
  • Rescue strop, double-lift harness, and basket stretcher hookup discipline
  • Emergency cable-shear protocols if the hoist hook snags on a moving vessel

Static Discharge and Hi-Line Deck Control

Spinning helicopter rotor blades slice through dry air, dust, or sea spray, building thousands of volts of electrostatic charge on the airframe. Touching an ungrounded hoist hook directly on a steel ship deck can deliver an incapacitating electric shock.

HERT teams drill strict grounding discipline: allowing the weighted static-discharge line or rescue hook to strike the deck or water first before any deckhand makes physical contact. On rolling decks, crews never wrap or tie a hi-line tag rope to ship railings—if the helicopter must break away abruptly, a secured line could pull the aircraft off balance.

Standardized Hand Signals and Noise-Resilient Comms

Underneath a hovering twin-engine helicopter, rotor noise exceeds 100 decibels, rendering shouted commands useless. HERT crews rely on crisp, unmistakable visual hand signals backed by dedicated UHF/VHF helmet intercoms between pilot, hoist operator, and deck coordinator.

Every person on the hoisting deck wears high-visibility helmets with eye protection, non-snagging gloves, and an auto-inflating or manual PFD suited to rotor blast—ensuring loose hats, rags, or deck debris are secured well ahead of aircraft arrival to prevent Foreign Object Damage (FOD).

  • Clear deck of all loose lines, tarps, antennas, and FOD before approach
  • Never secure the hoist hook or hi-line tag rope to any fixed ship structure
  • Maintain direct eye contact with the hoist operator during pick-up tension
  • Use unambiguous thumbs-up (ready to hoist) and crossed-arms (hold/abort) signals

Contingency Procedures: Pendulum Swing and Cable Hang-Up

Wind shear around vessel superstructures can induce hazardous pendulum oscillations as a rescue specialist ascends toward the cabin door. HERT simulator sessions teach rescuers body-position braking, tag-line tensioning, and controlled cabin-sill entry without striking the airframe.

Just as vital, crews rehearse worst-case scenarios—hoist motor failure, hydraulic overrun, and snagged cable hang-ups—practicing rapid decision thresholds for manual cranking or explosive cable shear activation to protect both aircraft and survivor.

HERT Hoist Operations Role & Hazard Controls

Hoist Team RolePrimary DutyCritical Safety ControlAbort / Emergency Trigger
Pilot in CommandHold steady hover reference over deckClear horizon/rig reference cuesSudden loss of visual cue or tail-rotor margin
Hoist OperatorControl cable speed & guide pilotMonitor cable fleet angle & tensionSnagged cable or hydraulic jam
Rescue SpecialistAssess survivor & secure harnessVerify gated carabiner & strap routingUnsecured load or severe deck roll
Vessel Deck LeadClear FOD & manage unattached hi-lineNever cleat or wrap hi-line to railsRigging obstruction or crew fall
Survivor / PatientKeep arms down inside rescue stropDo not grab cable or reach for skidPanic dislodging chest strap

Always brief vessel masters via VHF prior to helicopter arrival on static grounding and hi-line non-attachment rules.

Worked Illustration: Vessel Deck Preparation for a Stretcher Hoist

This worked illustration outlines the pre-arrival sequence a deck team follows before a SAR or HERT helicopter lowers a rescue basket onto a 40-meter vessel.

  1. 1. Clear & Brief (T-15 min): Secure loose hatches, lower whip antennas in the aft hoisting zone, and assign two deckhands in helmets, goggles, and PFDs.
  2. 2. Course & Wind (T-5 min): Vessel steams at steady speed placing relative wind 30°–45° off the port bow so the helicopter hovers into clean airflow.
  3. 3. Grounding & Hi-Line (Hover): Allow the weighted hi-line and hoist hook to touch the steel deck first to bleed static electricity; tend the tag line loosely in gloved hands—never tie it off.
  4. 4. Hookup & Lift: Clip the stretcher bridle securely, double-check gate closure visually, step clear of the cable bight, and give a crisp thumbs-up to the hoist operator.

Worked Illustration Result: Following static-grounding and loose hi-line rules prevents shock injuries and ensures an instant, snag-free breakaway if the helicopter aborts.

Hoist Emergency Response (HERT) Operational Checklist

  • Inspect hoist cable, hook swivel, and double-locking carabiners prior to every training or flight block.
  • Remove all loose deck gear, tarps, and unsecured tools to prevent rotor-wash FOD.
  • Never touch the hoist hook or metal basket before it grounds onto the deck or water.
  • Never attach a hi-line or guide rope to vessel cleats, railings, or stanchions.
  • Keep survivor arms tucked downward inside a rescue strop throughout vertical lift.
  • Rehearse cable-foul hand signals and emergency shear callouts in every crew briefing.

Frequently Asked Questions

Why must a helicopter hoist hi-line never be tied off to a boat railing?

If the helicopter experiences engine trouble or sudden wave impact forces an immediate climb, a tied-off hi-line acts as a tether that can tip or drag the aircraft into a crash.

Why do you let the hoist cable touch the deck or water before grabbing it?

Rotor blades generate intense static electricity. Grounding the cable against the sea or steel hull neutralizes the voltage safely before a crew member touches the metal hook.

What is the biggest mistake untrained survivors make in a rescue strop?

Raising their arms upward in panic—which can allow the rescue sling to slip over their elbows and head. Arms must stay folded downward tightly over the chest.

Who benefits from HERT training besides SAR flight crews?

Offshore wind technicians, coast guard auxiliary crews, commercial tug/supply deckhands, and industrial emergency response teams frequently coordinate with hoist aircraft.

Primary References & Standards

  • Transport Canada — Canadian Aviation Regulations (CARs) Part VII: External Load & Hoist Operations
  • International Civil Aviation Organization (ICAO) — Annex 6 & International Aeronautical and Maritime Search and Rescue (IAMSAR) Manual
  • Canadian Coast Guard — Search and Rescue Helicopter Hoisting Procedures Manual

Related Technical Guides